Home Button  Buy Button 

Topic:   Heidenhain151 blockwisesetting to drip feed

By: GuestPosted on: Nov 1 2016 at 01:56:20 PM
I have been through your pages and cat find any correct setting

to use blockwise in remo mode

machine is on fe setting 9600 baud and all your pramaters are set from the 155 file


By: GuestPosted on: Nov 1 2016 at 07:34:03 PM
In DNC Setup

MODE = Heidenhain
FlowControl = Block-Wise

Also see This Page



By: GuestPosted on: Nov 7 2016 at 01:11:50 PM
TNCServer software from Heidenhain is the good for transferring programs from the PC into heidenhain memory - At the CNC console you can browse the PC folders and select the file you want. Good if PC is a long distance from cnc.

But I've never been able to get that to drip feed a long program that doesn't fit in the machine memory. In that case you use easydnc. put the machine so that its ready to run then go to the PC and send the program.

Cheap windows tablet stuck on the side of the machine is ideal. File is on the main server and the tablet is just used to pull the file from the server and drip feed it into the machine. Once you get used to it its actually esier to use than tncserver.

Reply - add a comment to this topic.

You may enter letters, numbers and standard punctuation only. HTML and other scripts/tags will be rejected.

Topic:- Heidenhain151 blockwisesetting to drip feed


Enter the numbers.

Your name here is optional